I'm trying to use Build for Duke3d. It loads just fine, but when I try to do certain things, it doesn't work. I can make a room in 2D mode, but I can't switch to 3D mode. I can add sprites, but I can't insert a point onto a wall. I have no clue what is going on and it frustrates me.
Does anyone know what might be causing the problem?
Duke3d Build
Moderator: Moderators
I have a similar problem
In my case I can open Build in 3d but I cannot switch to 2D. Also the keyboard commands seem to have been messed about - some work such as applying materials, but if I try to scale a material it goes crazy. Did you get any solution to your problem?
Re: I have a similar problem
I've come across the same problems you guys have been having. My solution to the problem was to install a program called vmware (its like a virtual computer) and then install windows 98 into vmware (so i can run win98 within xp). If I load up build in win98 i'm able to switch between 2d and 3d modes and I can insert points, etc.Bob the Builder wrote:In my case I can open Build in 3d but I cannot switch to 2D. Also the keyboard commands seem to have been messed about - some work such as applying materials, but if I try to scale a material it goes crazy. Did you get any solution to your problem?
I'm having a problem though....when i switch over to 3d mode, the screen is garbled and I can't really do anything...I know I've run into this problem years ago when I first started using build, but I can't remember how to fix it....any suggestions?
- Lord Molder
- Cultist
- Posts: 275
- Joined: Sat Apr 16, 2005 6:04 pm
- Location: Australia